How to properly find your stance
Opening day, cold temps, and a parking lot. You’re setting up your new board in the parking lot and realize that if you keep doing this you won’t feel your hands after awhile…
Don’t be that guy. Be ready when opening day comes. Set up your in a heated shelter. All you need is a screwdriver and a little bit of knowledge. A tape measure can also help too.
TIP 1: Angles
This is the direction your toes will point when strapped into the board. First, lay your board on an even surface, then stand on top of it. See what feels comfortable, having your angles the opposite or the same. The basic stance angles are between -18 to 18 degrees. If you’re planning on riding switch, make sure you have a little “Duck” to your stance. This means that your back foot is the opposite angle of your front foot. So say your front foot is a 15, your back foot would then be a negative 15. If your goal is to do some harsh carves, put both bindings at a positive angle. Try a variety of stances to see what you’re most comfortable with.
TIP 2: Width
The width of the stance is the distance between the center of each binding. To measure what your stance width would be, measure from heel to knee cap. This is what the normal distance is for most people. Make sure of one thing, that it is not uncomfortably wide or narrow. The typical stance width is a tad wider than your shoulders. The most important thing is to not feel awkward while strapped into your board.
TIP 3: Throwing it all together
For this step you are going to need a #3 Phillips head screwdriver. First, place the bindings on the board where you found what was most comfortable. Now you are going to want to place the center plates or as we like to call them cookies in the bindings. Make sure that the holes in the cookies match up with the screw holes on the board. Place the bolts in the correct spot, use the #3 Philips head screwdriver to tighten the bolts. An easy way to test the stance is to make the bolts loose and stand in the bindings. This way it will be easier to re-adjust them if it doesn’t feel right.
Once you have the bindings on and tightened, it’s time to strap in. When you strap in, make sure the binding strap is centered around the boot. If it is not centered you might have uneven pressure points, which suck by the way. If the straps aren’t centered, there should be something on the strap that lets you tighten and or loosen it.
TIP 4: Finishing touches
Before hitting the slopes you are going to want to dull or sharpen your edges. If you hit rails you are going to want to dull the edges just enough so it reduces the chances of you catching an edge. To dull or sharpen them you are going to need a file. Watch this short video on how to dull your edges. After you finished the technical part, it’s time to make your board look good. As everyone calls it, a “sticker job”, is an inexpensive way to make your board look slick. Die cut stickers or regular stickers can turn any board into a masterpiece. You just have to find stickers that you like!